Page Comparison

...

The serial number and MAC address can be found on the back of the GL.iNET router

...

Adding Cameras to

...

GL.iNET Gateway

1. Add Uplink Cameras to your Cloud VMS platform for each camera you are going to connect through the GL.iNET bridge. You’ll need the following information for each camera:

   1. Camera username.

   2. Camera password.

   3. Camera serial number (should be printed on a camera)

   4. Camera MAC address (should be printed on a camera)

...

2. Navigate to the plugin interface: http://<GLINET-IP>/cgi-bin/luci/admin/services/uplink-gateway and then navigate to the Camera Config tab

3. After adding each camera to Cloud VMS, add the same camera serial number and MAC address into the Camera Form of the plugin’s interface, plus the local IP address of the camera. Make sure to enable each camera you want to add.
   

   

   Then scroll down to the bottom of the page and click Save & Apply.
   Note. Default ports for IP Cameras are usually http: 80, rtsp: 554
   

4. Then navigate to http://<GLINET-IP>/cgi-bin/luci/admin/services/uplink-gateway and click ‘Start Cameras’ to start the application.
   

   

Troubleshooting

Checking Logs

A key aspect of knowing the cause of an issue is being able to see what is occurring on the device.
The device logs can be accessed at http://<GLiNET-IP>/cgi-bin/luci/admin/status/logs.

Rebooting Gateway Services

All Uplink services can be restarted by navigating to http://<GLiNET-IP>/cgi-bin/luci/admin/services/uplink-gateway/settings and clicking ‘Restart Gateway’

...